mirrors/keychron_qmk_firmware
mirrors/keychron_qmk_firmware
0
0
Fork 0
mirror of https://github.com/Keychron/qmk_firmware.git synced 2024-11-22 00:16:41 +06:00
Code Issues Packages Projects Releases Wiki Activity
master
keychron_qmk_firmware/keyboards/adafruit/macropad/readme.md

2.1 KiB
Raw Permalink Blame History

Adafruit MacroPad RP2040

AdafruitMacropad

A RP2040-powered Macropad with a 3x4 layout.

Make example for this board (after setting up your build environment):

qmk compile -kb adafruit/macropad -km default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Features

  • Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual-core Cortex M0+ at ~130MHz with 264KB of RAM.
  • 3x4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
  • One NeoPixel RGB LED per switch, on north side.
  • Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.
  • 128x64 SH1106 Monochrome OLED display - On high-speed hardware SPI port for quick updates.
  • 8mm Speaker/Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects. (Unsupported for now)
  • STEMMA QT Connector - Allows adding any I2C sensors/displays/devices with plug-and-play cables.
  • Reset button - On the side, for quick restarting, press it twice to enter bootloader.
  • Four M3 mounting bosses - Make custom enclosures easily.

Bootloader

Enter the bootloader in 4 ways:

  • Bootmagic reset: Hold down the key just below the rotary encoder push-button on power-up.
  • Physical reset button: Press twice the button on the side while the board is connected.
  • BOOT button Hold down the rotary encoder push-button on power-up or reset.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available.