eba4cb7a04
* Cleanup Mechmini keymap. Once the custom RGB function is defined, there is no need to manually handle RGB code. * Change default to KEYMAP_MIT, not KEYMAP_OFFSET * Add custom RGB code for JJ40 * Reset Mechmini advertised power draw to 500. Will have to test actual maximum power draw later. * RGB working on JJ40. * Fix: saturation increase/decrease flipped * Add new directory for my custom keymap with RGB keycodes * Swap LAlt and LGUI * Update JJ40 max power draw with measured value * Update: fun40 rules.mk to enable underglow; earlier failed Travis CI |
||
|---|---|---|
| .. | ||
| keymaps/default | ||
| config.h | ||
| i2c.c | ||
| i2c.h | ||
| matrix.c | ||
| mechmini.c | ||
| mechmini.h | ||
| readme.md | ||
| rules.mk | ||
| usbconfig.h | ||
mechmini
A compact ortholinear/staggered keyboard.
Keyboard Maintainer: QMK Community
Hardware Supported: mechmini PCB
Hardware Availability: https://mechkeys.ca/collections/keyboards/products/mechmini-2-0-pcb
Make example for this keyboard (after setting up your build environment):
make mechmini:default
See build environment setup then the make instructions for more information.
Mechmini Notes
Note that this is a complete replacement for the firmware, so you won't be using Bootmapper Client to change any keyboard settings, since not all the USB report options are supported.
Installing
First, install the requirements. These commands are for OSX, but all you
need is the AVR toolchain and bootloadHID for flashing:
$ brew cask install crosspack-avr
$ brew install --HEAD https://raw.githubusercontent.com/robertgzr/homebrew-tap/master/bootloadhid.rb
In order to use the ./program script, which can reboot the board into
the bootloader, you'll need Python 2 with PyUSB installed:
$ pip install pyusb
Then, with the keyboard plugged in, simply run this command from the
qmk_firmware directory:
$ make mechmini:program
If you prefer, you can just build it and flash the firmware directly with
bootloadHID if you boot the board while holding down L_Ctrl to keep it
in the bootloader:
$ make mechmini
$ bootloadHID -r mechmini_default.hex
Troubleshooting
From my experience, it's really hard to brick these boards. But these tricks have been useful when it got stuck in a weird scenario.
- Try plugging the board in while pressing
L_Ctrl. This will force it to boot only the bootloader without loading the firmware. Once this is done, just reflash the board with the original firmware. - Sometimes USB hubs can act weird, so try connecting the board directly to your computer or plugging/unplugging the USB hub.