keychron_qmk_firmware/keyboards/a_dux

Architeuthis Dux

AKA A. dux, A.D., "Giant squid"

34 keys, same stagger as D. gigas, but with two thumb keys included. Pinky, ring, index, and inner columns splayed at 15, 5, 0, -5, -5 degrees. SplitKB Tenting Puck support. All PCB files are available on the project's github page

Thank you Perce for the logo.

Case Options

• Flat Case
• Tented Case
• Case with Plates

Keyboard Info

• Keyboard Maintainer: @tapioki
• Hardware Supported: Architeuthis Dux
• Hardware Availability: Order PCBs with gerber files from the repository

Make example for this keyboard (after setting up your build environment):

make a_dux:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Setting Handedness

Firmware uses handedness by EEPROM as default and it must be configured once on each side. The make commands are:

make a_dux:default:dfu-split-left
make a_dux:default:dfu-split-right

QMK Toolbox can also be used to set EEPROM handedness. Place the controller in bootloader mode and select menu option Tools -> EEPROM -> Set Left/Right Hand

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the top left key on the left half (or the top right right key on the right half) and plug in the controller on that side.
• Physical reset pins: Briefly short the RST and GND pins on the microcontroller using tweezers, a paperclip, or any other conductive material.
• Keycode in layout: Press the key mapped to QK_BOOT if it is configured.