keychron_qmk_firmware/keyboards/wolf/ts60
Ryan 56555c61e1
Migrate LAYOUTS to data driven (#19541)
* Migrate `LAYOUTS` to data driven, 0-9

* Migrate `LAYOUTS` to data driven, A

* Migrate `LAYOUTS` to data driven, B

* Migrate `LAYOUTS` to data driven, C

* Migrate `LAYOUTS` to data driven, D

* Migrate `LAYOUTS` to data driven, E

* Migrate `LAYOUTS` to data driven, F

* Migrate `LAYOUTS` to data driven, G

* Migrate `LAYOUTS` to data driven, H

* Migrate `LAYOUTS` to data driven, handwired

* Migrate `LAYOUTS` to data driven, I

* Migrate `LAYOUTS` to data driven, J

* Migrate `LAYOUTS` to data driven, K

* Migrate `LAYOUTS` to data driven, L

* Migrate `LAYOUTS` to data driven, M

* Migrate `LAYOUTS` to data driven, N

* Migrate `LAYOUTS` to data driven, O

* Migrate `LAYOUTS` to data driven, P

* Migrate `LAYOUTS` to data driven, Q

* Migrate `LAYOUTS` to data driven, R

* Migrate `LAYOUTS` to data driven, S

* Migrate `LAYOUTS` to data driven, T

* Migrate `LAYOUTS` to data driven, U

* Migrate `LAYOUTS` to data driven, V

* Migrate `LAYOUTS` to data driven, W

* Migrate `LAYOUTS` to data driven, X

* Migrate `LAYOUTS` to data driven, Y

* Migrate `LAYOUTS` to data driven, Z
2023-01-10 02:48:20 +00:00
..
keymaps
config.h
info.json Migrate LAYOUTS to data driven (#19541) 2023-01-10 02:48:20 +00:00
readme.md
rules.mk Migrate LAYOUTS to data driven (#19541) 2023-01-10 02:48:20 +00:00
ts60.c
ts60.h

Wolf - TS 60

The following is the QMK Firmware for the TS60 PCB.

The PCB features:

  • QMK & VIA compatibility
  • RGB underglow
  • Per-Key LEDs

  • Keyboard Maintainer: ToastyStoemp
  • Hardware Supported: TF60 ANSI SOLDER

Make example for this keyboard (after setting up your build environment):

make wolf/ts60:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key ESC key and plug in the keyboard (Top Left most switch)
  • Physical reset button: Briefly press the button on the back of the PCB
  • Keycode in layout: Press the Enter key on layer 1 which is mapped to QK_BOOT