keychron_qmk_firmware/keyboards/handwired/snatchpad

snatchpad

A 6-key macropad with 2 rotary encoders intended for use as a pointing device.

In addition to the 3d printed parts and microcontroller, the following hardware is required:

• 4 * 3x3 mm threaded inserts
• 4 * 4mm M3 bolt
• USB daughter board

---

• Keyboard Maintainer: xia0
• Hardware Supported: e.g. Arduino Pro Micro
• Hardware Availability: github

Make example for this keyboard (after setting up your build environment):

make handwired/snatchpad:default

Flashing example for this keyboard:

make handwired/snatchpad:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available