keychron_qmk_firmware/keyboards/handwired/3dfoxc

3dfoxc

A 3d-printed whitefox with an Elite-C microcontroller.

This is a build of matt3o's "How to Build a Custom Keyboard" guide, except that I have replaced the Teensy with an Elite-C v4. Presumably you could replace it with anything compatible. The USB-C port had to be enlarged with dremel, and the mount for the Teensy was ground off and replaced with everyone's favorite rapid modeling polymer ... hot glue.

• Keyboard Maintainer: david l goodrich
• Hardware Supported:
  • 3d-printed whitefox
  • Elite-C microcontroller
• Hardware Availability: keebio, 1up, keyhive, splitkb

Wiring

Badly, because I have never done this before. Build pics available upon request, I guess.

Flashing

Make example for this keyboard (after setting up your build environment):

make handwired/3dfoxc:default

Flashing example for this keyboard (use the dfu target for the Elite-C!):

make handwired/3dfoxc:default:dfu

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to RESET if it is available