keychron_qmk_firmware/keyboards/ergodox_ez/post_config.h

#pragma once

#if !defined(ERGODOX_LED_15) && !defined(ERGODOX_LED_30)
// if no value is defined, assume previous behavior
// #    define ERGODOX_LED_15
// #    define ERGODOX_LED_30
#    define ERGODOX_LED_15_MIRROR
#endif

#if (defined(ERGODOX_LED_30) + defined(ERGODOX_LED_15) + defined(ERGODOX_LED_15_MIRROR)) != 1
#    error "You must only define one of the ERGODOX_LED options."
#endif

#ifdef ERGODOX_LED_30
// If using 30 LEDs, then define that many
#    define RGBLED_NUM 30  // Number of LEDs
#else
// If not, then only define 15
#    define RGBLED_NUM 15  // Number of LEDs
#endif
Move Ergodox EZ RGB Light code to custom driver (#7309) * Move Ergodox EZ RGB code to custom driver Also implements full addressing of Ergodox EZ's LED Strip, as written by seebs Co-authored-by: Seebs <seebs@seebs.net> * Make Clipping range accessible for custom drivers * Remove RGBW_BB_TWI from driver and docs * Revert changes to clipping range support * Use just rgblight_set instead of full custom driver * Convert to i2c_master commands * Rename rgblight driver and clean up includes 2019-11-15 02:00:51 +06:00			`#pragma once`

			`#if !defined(ERGODOX_LED_15) && !defined(ERGODOX_LED_30)`
			`// if no value is defined, assume previous behavior`
			`// # define ERGODOX_LED_15`
			`// # define ERGODOX_LED_30`
			`# define ERGODOX_LED_15_MIRROR`
			`#endif`

			`#if (defined(ERGODOX_LED_30) + defined(ERGODOX_LED_15) + defined(ERGODOX_LED_15_MIRROR)) != 1`
			`# error "You must only define one of the ERGODOX_LED options."`
			`#endif`

			`#ifdef ERGODOX_LED_30`
			`// If using 30 LEDs, then define that many`
			`# define RGBLED_NUM 30 // Number of LEDs`
			`#else`
			`// If not, then only define 15`
			`# define RGBLED_NUM 15 // Number of LEDs`
			`#endif`