keychron_qmk_firmware/keyboards/mechlovin/hannah60rgb/rev2/config.h
mechlovin 793de76bb4
[Keyboard] Add hannah60rgb rev.2 PCB (#10287)
* add hannah60rgb_rev2

* add

* Update rev2.c

* fixed rgb matrix

* Update rev2.c

* update rules.mk

* update readme

* update

* Update config.h

* Update rules.mk
2020-10-04 12:23:35 -07:00

40 lines
1.7 KiB
C

#pragma once
#define PRODUCT_ID 0x6002
#define DEVICE_VER 0x0001
#define PRODUCT Hannah60 RGB Rev.2
#ifdef RGBLIGHT_ENABLE
# define RGB_DI_PIN A15
# define RGBLED_NUM 18
# define RGBLIGHT_ANIMATIONS
# define RGBLIGHT_HUE_STEP 8
# define RGBLIGHT_SAT_STEP 8
# define RGBLIGHT_VAL_STEP 8
#endif
//rgb matrix setting// This is a 7-bit address, that gets left-shifted and bit 0
// set to 0 for write, 1 for read (as per I2C protocol)
// The address will vary depending on your wiring:
// 0b1110100 AD <-> GND
// 0b1110111 AD <-> VCC
// 0b1110101 AD <-> SCL
// 0b1110110 AD <-> SDA
#define DRIVER_ADDR_1 0b1110100
#define DRIVER_ADDR_2 0b1110110
#define DRIVER_COUNT 2
#define DRIVER_1_LED_TOTAL 44
#define DRIVER_2_LED_TOTAL 34
#define DRIVER_LED_TOTAL (DRIVER_1_LED_TOTAL + DRIVER_2_LED_TOTAL)
#define RGB_MATRIX_KEYPRESSES // reacts to keypresses
#define RGB_MATRIX_KEYRELEASES // reacts to keyreleases (instead of keypresses)
#define RGB_MATRIX_FRAMEBUFFER_EFFECTS
#define RGB_DISABLE_AFTER_TIMEOUT 0 // number of ticks to wait until disabling effects
#define RGB_DISABLE_WHEN_USB_SUSPENDED false // turn off effects when suspended
#define RGB_MATRIX_LED_FLUSH_LIMIT 16 // limits in milliseconds how frequently an animation will update the LEDs. 16 (16ms) is equivalent to limiting to 60fps (increases keyboard responsiveness)
#define RGB_MATRIX_MAXIMUM_BRIGHTNESS 255 // limits maximum brightness of LEDs to 200 out of 255. If not defined maximum brightness is set to 255
#define RGB_MATRIX_STARTUP_MODE RGB_MATRIX_CYCLE_PINWHEEL // Sets the default mode, if none has been set
#if defined(RGBLIGHT_ENABLE) && defined(RGB_MATRIX_ENABLE)
# define RGB_MATRIX_DISABLE_KEYCODES
#endif