mirror of
https://github.com/Keychron/qmk_firmware.git
synced 2024-12-13 13:46:51 +06:00
baa564bddf
* Remove references to bootloadHID flashing page in keyboard readmes * Remove bootloadHID flashing page
31 lines
1.3 KiB
Markdown
31 lines
1.3 KiB
Markdown
# Unikorn 60
|
|
|
|
60% PCB made for the TGR x SINGA Unikorn60.
|
|
|
|
* Keyboard Maintainer: [MechMerlin](https://github.com/mechmerlin)
|
|
* Hardware Supported: Unikorn 60 PCB
|
|
* Hardware Availability: [Geekhack GB](https://geekhack.org/index.php?topic=98350.0)
|
|
|
|
Make example for this keyboard (after setting up your build environment):
|
|
|
|
make unikorn:default
|
|
|
|
Flashing example for this keyboard:
|
|
|
|
make unikorn:default:flash
|
|
|
|
**Reset Key**: Short the two holes labeled `FW_JP` underneath the PCB, beside the Tab key while plugging in the keyboard.
|
|
|
|
Do not confuse this with the LED holes of the switch in the `Tab` position. `FW_JP` is not reachable from the top as the plate blocks access to it.
|
|
|
|
See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
|
|
|
|
## RGB Underglow
|
|
This PCB can support RGB underglow. There are pads on the bottom of the PCB for the LED controller chip and for 17 RGB underglow LEDs. The Unikorn 60 case does not have acrylic pieces to properly display underglow effects.
|
|
|
|
To enable RGB lighting support, install the necessary components and set RGBLIGHT features in `rules.mk` like so:
|
|
|
|
```makefile
|
|
RGBLIGHT_ENABLE = yes
|
|
```
|