mirror of
https://github.com/Keychron/qmk_firmware.git
synced 2024-12-12 05:06:38 +06:00
13a514923a
Co-authored-by: Tyler Tidman <tyler.tidman@draak.ca> Co-authored-by: Simon Arlott <sa.me.uk>
52 lines
1.8 KiB
Markdown
52 lines
1.8 KiB
Markdown
# K3X0 = K310, K320, etc.
|
|
|
|
This K3X0 code is shared between both the ANSI and ISO variants of both the
|
|
K310 full-sized 104/105-key and K320 TKL 87/88-key keyboards.
|
|
|
|
* Keyboard Maintainers: [dkjer](https://github.com/dkjer) and [tylert](https://github.com/tylert)
|
|
* Hardware Supported: Durgod Taurus K310 or K320 board with STM32F070RBT6
|
|
* Hardware Availability: K310 https://www.durgod.com/page9?product_id=53&_l=en
|
|
and K320 https://www.durgod.com/page9?product_id=47&_l=en
|
|
|
|
## Instructions
|
|
|
|
### Build
|
|
|
|
Instructions for building the K310 and K320 firmware can be found here:
|
|
* [K310](k310/readme.md)
|
|
* [K320](k320/readme.md)
|
|
|
|
### Initial Flash
|
|
|
|
For first Flashing from initial Stock Firmware
|
|
|
|
1. Back up original Firmware Image:
|
|
- Unplug
|
|
- Short Boot0 to Vdd (See below)
|
|
- Plug In USB
|
|
- Make a Flash Image's Backup in case you wanted to restore the Keyboard to Stock's Image:
|
|
- Using dfu-util:
|
|
|
|
dfu-util --list
|
|
dfu-util --alt 0 --dfuse-address 0x08000000 --upload ${OLD_STOCK_BIN}
|
|
|
|
2. Flash the QMK Firmware Image.
|
|
- Put board into Bootloader mode, using the same method as when backing up the original Firmware (above)
|
|
- Here are a few options for performing the initial Flash:
|
|
- Using [QMK Toolbox](https://github.com/qmk/qmk_toolbox)
|
|
- Using dfu-util:
|
|
|
|
dfu-util --alt 0 --dfuse-address 0x08000000 --download ${NEW_QMK_BIN}
|
|
|
|
You can short Boot0 to Vdd by shorting R21 to C27 on the sides closest to the processor, as shown:
|
|
|
|
<img src="https://i.imgur.com/hvDnw5a.jpg" width="520" height="693" alt="Shorting Boot0 to Vdd on K320">
|
|
|
|
### Subsequent Flashing
|
|
|
|
For repeating Flashing you can use BootMagic:
|
|
- BootMagic Lite has been enabled with Assigned "Esc" key
|
|
- Unplug USB Cable
|
|
- Holding Esc Button
|
|
- Plug in USB Cable, Keyboard should be in ST-Bootloader state
|